Novell Server Consolidation and Migration Toolkit 1.2, Руководство администратора

Страница: 117 / 130

Troubleshooting Server Migrations 117
no
vd
ocx
(e
n)
6 Ap
ril 20
07
If a message appears saying that NDS/eDirectory has already been removed, bring the
destination server down and continue with the next section,
Remove NDS/eDirectory from the
Source Server .
If NDS/eDirectory was not successfully removed, exit NWCONFIG and enter
nwconfig -
dsremove
at the destination server console. Then follow this procedure again, beginning with
Step 2 on page 116 .
12.5.3 Remove NDS/eDirectory from the Source Server
After NDS/eDirectory has been removed from the destination server, remove NDS/eDirectory from
the source server.
1 Restart the source server by entering
server
at the DOS command prompt.
2
Enter one of the following:
Š load install -dsremove
(if source server is running NetWare 4)
Š
nwconfig -dsremove
(if source server is running NetWare 5 or later)
INSTALL or NWCONFIG will now ignore any warnings or errors during the removal of NDS.
3
Select Directory Options > Remove Directory Services from This Server .
4 Press Enter to skip past any warning screens.
5
Select Yes to remove NDS/eDirectory.
6 Press Enter to skip the error message warning you that eDirectory is locked.
Ignore, but keep track of, any additional eDirectory error messages that appear.
7 When the INSTALL or NWCONFIG menu appears again, select Remove Directory Services
again.
If a message indicates that eDirectory is already removed, continue with the next section, Restore
NDS/eDirectory to the Source Server .
If eDirectory was not properly removed, contact Novell Support (http://www.novell.com/support) .
12.5.4 Restore NDS/eDirectory to the Source Server
By removing NDS/eDirectory from the source server, you removed the server from any replica rings
that held a partition of the source server. Now you must complete the following procedure to restore
NDS/eDirectory to the source server.
1
Enter one of the following at the server console:
Š load install
(if source server was running NetWare 4)
Š
load nwconfig
(if source server was running NetWare 5 or later)
2 Select Directory Services > Install Directory Services onto This Server .
3 Select the eDirectory tree where the source server existed prior to migration.
4 Select a time zone and time configuration parameters.
Make a note of any warnings or errors that appear during the restoration of eDirectory and
press Esc to continue without fixing the errors.
5 Enter the Admin name and password.