Novell GROUPWISE 7 - INTEROPERABILITY GUIDE, Руководство пользователя

Страница: 146 / 485

146 GroupWise 7 Interoperability Guide
n
ov
do
cx (e
n)
11
Ju
ly 20
08
9 Rebuild the post office database for the new post office, following the steps provided in
“
Rebuilding Domain or Post Office Databases ” in “ Databases ” in the GroupWise 7
Administration Guide . Be sure to browse to the database location ( under System Clustering
Worksheet item 11 ) through the GroupWise partition.
The database rebuild is necessary in order to transfer the POA configuration information and
the post office link information into the post office database, because the POA for the new post
office is not yet running.
10 If you want to create a library with its document storage area outside the post office directory,
follow the steps in “
Setting Up a Basic Library ” or “ Setting Up a Full-Service Library ” in
“ Libraries and Documents ” in the GroupWise 7 Administration Guide , after you have
completely finished setting up the clustered post office.
11 Continue with Installing and Configuring the MTA and the POA in a Cluster to install the POA
software for the new post office.
14.4 Installing and Configuring the MTA and the
POA in a Cluster
By following the instructions in Section 14.1, “Setting Up a New GroupWise System in a Linux
Cluster,” on page 143 , you installed the MTA and the POA on the first node in your cluster, as well
as created the initial domain and post office in your GroupWise system. You are now ready to install
and configure the agents on additional nodes and set up the agent software for use in your cluster.
Š
Section 14.4.1, “Installing and Setting Up the Agents in Your Cluster,” on page 146
Š
Section 14.4.2, “Changing Agent Paths to Locations on GroupWise Partitions,” on page 150
Š
Section 14.4.3, “Configuring GroupWise Cluster Resources to Load and Unload the Agents,”
on page 152
Š Section 14.4.4, “Setting Up New Instances of the Agents without Installing the Agent
Software,” on page 158
If you have added a new secondary domain or a new post office to an existing GroupWise system,
the agent software has already been installed and you simply need to create a new startup file
specific to the new domain or post office. In these circumstances, follow the instructions in
Section 14.4.4, “Setting Up New Instances of the Agents without Installing the Agent Software,” on
page 158
instead of completing the tasks above.
14.4.1 Installing and Setting Up the Agents in Your Cluster
The agents must be installed on each node in domain failover list ( Agent Clustering Worksheet item
2 ) and the post office failover list ( Agent Clustering Worksheet item 5 ).
Š
“Running the GroupWise Installation Program on the Preferred Node” on page 147
Š “Running the GroupWise Installation Program on Subsequent Nodes” on page 148
Š
“Testing Your Agent Installation on Each Node” on page 150
After you have installed and tested the agents on each node in the cluster, continue with
Section 14.4.2, “Changing Agent Paths to Locations on GroupWise Partitions,” on page 150 .