Novell GROUPWISE 7 GATEWAY FOR MICROSOFT EXCHANGE - INSTALLATION AND ADMINISTRATION, Руководство по установке и администрированию, Страница: 115 / 144

Using Exchange Gateway Startup Switches 115
no
vd
ocx
(e
n)
6 Ap
ril 20
07
11.24 /rt
Specifies the number of receiver threads that the Exchange Gateway should start. The default it 4.
There is no limit to the number of threads you can start, but nothing is gained by starting threads that
are always idle. See
Section 10.2, “Adjusting the Number of Sender and Receiver Threads,” on
page 105 .
Syntax:
/rt- threads
Example:
/rt-3
See also /st .
11.25 /send
Puts the gateway in send-only mode, so that it sends messages to the Exchange system but does not
receive messages from the Exchange system.
Syntax:
/send
See also /recv .
11.26 /single
Instructs the gateway to run for one send/receive cycle, then shut down. For information about the
send/receive cycle, see
Section 10.1, “Adjusting the Gateway’s Send/Receive Cycle,” on page 103 .
Syntax:
/single
11.27 /st
Specifies the number of sender threads that the Exchange Gateway should start. The default it 4.
Valid values range from 1 to 4. See
Section 10.2, “Adjusting the Number of Sender and Receiver
Threads,” on page 105 .
Syntax:
/st- threads
Example:
/st-3
See also /rt .