Novell GROUPWISE 7 GATEWAY FOR MICROSOFT EXCHANGE - INSTALLATION AND ADMINISTRATION, Руководство по установке и администрированию, Страница: 105 / 144

Optimizing the Exchange Gateway 105
no
vd
ocx
(e
n)
6 Ap
ril 20
07
10.2 Adjusting the Number of Sender and
Receiver Threads
The Exchange Gateway can be configured to start from varying numbers of sender and receiver
threads, depending on the amount of traffic passing through the gateway. The heavier the traffic, the
more threads you should configure the gateway to start. By default, 4 sender threads and 4 receiver
threads are started.
Use the /st switch in the Exchange Gateway startup file (
gwexch.cfg
) to set the number of sender
threads. Use the /rt switch to set the number of receiver threads.
Exchange Gateway Web Console You can check the number of sender and receiver threads that
are currently available and in use on the Status page.
10.3 Automating Network Reattachment
When the Exchange Gateway loses its link to the server where the GroupWise domain directory
resides or its link to the Exchange server, it can attempt to reestablish the link.
1 In ConsoleOne, browse to and right-click the Exchange Gateway object, then click Properties .
2 Click GroupWise > Optional Gateway Settings to display the Optional Gateway Settings page.
3 Make sure that Enable Recovery is set to Yes .
4 Fill in the following fields:
Retry Count: Specify the number of times you want the gateway to attempt to recover the
network link. The default is 10 times.
Retry Interval: Specify the amount of time you want the gateway to wait between retry
attempts. The default value is 60 seconds.