NOVACAT V10 ED, Перевод оригинального руководства по эксплуатации

Страница: 17 / 86

- 17 -
1400_GB-Power Control_3843
POWER CONTROL
GB
Work menu
M2
In Start menu, press function key to open up Work menu.
Press function key to return to Start menu.
13
12
11
12
4
3
1
1
5
6
8
7
2
Note!
To adjust the
relief pressure the
mower units must
be in the neutral
position.
Note!
It is not possible
to change to road
transport position
when, at least,
one cross con-
veyor is not in the
working position.
Display:
1…. Cross conveyor belt speed:
Fast (hare)/Slow (tortoise) (only with X8 Collector)
2 ... Preselect to either raise or lower cross conveyor.
3 ... Operating condition of mower units:
Working (pic. 1), Field transport (pic. 2),
Road transport (pic. 3)
4 ... a cross conveyor is not in working position
5 ...
Tractor speed:
can only be selected if in configuration menu
6 ... ha. per hr.:
only if tractor speed is selected in configuration menu.
7 ...
Front mower available. If this symbol is not displayed,
there is either no front mower available or it
cannot be managed with this control.
8 ... Right rear mower unit relief pressure
9 ... Left rear mower unit relief pressure
10 ... Daily hectare counter only if tractor speed is
selected in configuration menu.
11 ... Slope travel preselection (only with Novacat V10)
12 ... Side shift (only with Novacat V10)
both arrows point outward = max. width
both arrows point inward = min. width
both arrowspoint in the same direction
= slope travel
13 ... Road transport symbol
Only with the symbol displayed is raising and
lowering out of, or to, the road transport position
possible. If symbol begins to flash then press
[Road transport] key once again.
Function keys:
... Decrease relief pressure of rear
mower units*
... Increase relief pressure of rear mower
units*
... Activate/deactivate front mower
... Go up one menu level (here: Start
menu)
Hard keys: Raising and lowering
*Momentary pressure differences could arise between left and right rear mower units. But these are
automatically balanced out after the filling process.
9
10