NOVACAT V10 ED, Перевод оригинального руководства по эксплуатации

Страница: 31 / 86

- 31 -
1401_GB-ISObus Terminal_3846
ISOBUS TERMINAL
GB
Start menu
T6
T1
T2
T3
T4
T5
F1
T1 STOP
T2 Work menu
T3 Transport menu
T4 Data menu
T5 Set menu
T6 Test menu
STOP-key function
To stop all procedures currently running.
ESC key function
To return to previous menu.
Work menu
T1
T2
T3
T4
T7
T8
T9
T10
F2
T1
Raise/lower left mower unit
T2
Raise/lower right mower unit
T3
Increase relief pressure*
T4
Decrease relief pressure*
T7
Automatic "Raise mower units" function
T8
Automatic "Lower mower units" function
T9
"Change speed" (only X8 Collector)
T10 Navigating the "Side shift" menu
- Change to mask (F3)
Meaning of keys
*Momentary pressure differences could arise between left and right rear mower units. But these are
automatically balanced out after the filling process.
Meaning of display:
a
b
c
d
e
f
g
a
... Rotations (U/min) of the driveshaft
b
... Status of curved cut optimisation
Curved cut optimisation OFF
Curved cut optimisation ON but inactive
Curved cut optimisation ON and active after
the expiry of the delay interval, as long as the
machine is in working position.
c
... Mower position: Work / headland / transport
d
... Lateral traversing position
e
... Release pressure on the right (above) and left
(beneath)
f
... Partial hectare counter (see the Data menu)
g
... Working speed in km/h and ha/h
T6
T1
T2
T3
T4
F3
T1 Increase working width
T2
Decrease working width
T3
Lateral traversing left
T4
Lateral traversing right
T6 Switch-on of curved cut optimisation
The curved cut optimisation, also when switched
on, is active only in working position.