NOVACAT V10 ED, Перевод оригинального руководства по эксплуатации

Страница: 45 / 86

Alter roller position: (as required)
WS
021-09-11
The roller position changes if the drive chains
are re-tensioned several times.
Alter roller position:
Loosen the screws (WS) and rotate the roller. Set the po-
sition of the lower roller so that the profile of both rollers is
optimally interlock and not touch each other.
Optimum roller position reduces wear on
the rubber rollers.
Drive belts: (as required)
RS
SE
Check belt tension:
• Basic setting (SE): 200 mm
Changing belt tension:
• Adjust screw (RS)
Replacing belts:
When the drive belts show signs of damage or wear, they
must be replaced. (Note: Always replace the complete
belt set!)
• Loosen belt tension. In support, use the blade quick-
change spanner to deactivate the belt tensioner.
• Replace belt
• Restore belt tension
Lubrication:
(After every 50 operating hours)
SP1
• SP1
(Every 100 operating hours)
SP1
SP2
• SP 2 (Unscrew the top cover to lubricate!)
Gear oil:
(After every 100 operating hours)
BS
AS
CS
The gearbox is located on the outside of the cutter bar.
• Open drain plug (AS) and drain oil
• Fill gear oil (700ml) at filling screws (BS)
• CS = oil level
(Fully synthetic lubricating oil for high-
temperature lubrication, ISO-VG class 220)
- 45 -
1600-GB_WALZENAUFBEREITER_3843
ROLLER CONDITIONER
GB