NOVACAT V10 ED, Перевод оригинального руководства по эксплуатации

Страница: 54 / 86

- 54 -
1601_GB-MAINTENANCE_3846
MAINTENANCE
GB
4. Oil level check
Important information when measuring
the oil level:
You jack up the cutter bar depending on
the length.
The cutter bar width must be adjusted in
precise horizontal position. (see image).
The oil level is correct if the gear oil reaches the lower
edge of the level opening (63) (OIL LEVEL).
TD17/99/10
OIL LEVEL
5. Topping up oil
Complete with the missing oil quantity.
Note
• Too much oil can cause the cutter bar
to overheat during operation.
• Too little oil does not guarantee the
necessary lubrication.
Cutter bar oil level check
• Under normal operating conditions, oil is to be
replenished annually.
Caution
Cleaning and maintenance works shall
be performed only with the machine
turned off and the mowing units lowered.
Note:
Carry out oil level check at operating
temperature.
The oil is too viscous when cold. Too
much old oil sticks to the gearwheels
which then gives a false reading.
1. Lift one side of the mower bar X3 and support
it.
X3 = X2 + X1
X1 = Distance from ground to vats upper edge.
X2 = Distance from vats upper edge left to vats upper
edge right.
X3
X2 X1
NOVACAT V10: X2 = 300 mm
• The side where the oil refill screw is located remains
on the ground.
• Lift the other side of the mower bar about X1 and
support with a suitable prop.
2. Leave mower bar in this position for about 15
minutes.
• This time is necessary to allow the oil to collect in
the lower area of the mower bar.
3. Remove oil fill screw (63).
Measure oil level through the opening (63).
TD 17-99-13
63
OIL LEVEL