Nortel Passport 4400, Инструкция по использованию, Страница: 32 / 144

32
206906-D Rev 00 4.2
Configuring the Modem Attached to the PC
When you configure the modem that is attached to your PC, be sure to choose the
correct driver for the device. Once the modem is installed, configure the modem
properties with the phone number of the modem that is attached to the
Passport 4400.
Configuring the Modem Attached to the Passport 4400
The modem that is attached to the Passport 4400 must be configured for Quiet
operations (no result code, no command echo/local echo).
You use a terminal emulation program or a dumb terminal to configure the
modem. In either case, you must set the modem baud rate to match that of the
Passport 4400 management port (the default is 9600 baud).
Use your modem documentation and the procedure that follows as a guide to
configuring the modem.
Procedure
To configure a Hayes-compatible modem for Quiet operations, follow these steps:
1 Connect the PC (or terminal) to the modem.
Refer to your modem documentation to determine the cabling requirement.
2 Start the terminal emulation program.
3 Set the serial port baud rate to match that of the Passport 4400 management
port (the default is 9600 baud).
Caution: Do not connect a modem to the Passport 4400 management
port unless it is configured for Quiet operations (as described in the
procedure below). Otherwise, the unit will not boot up successfully
following a reset operation. Refer to your hardware manual for more
detailed information.