Nordson VersaBlue 100H/100H, Руководство пользователя

Страница: 85 / 108

1
Repair
7-5
P/N 7146386A
E 2008 Nordson Corporation
VBN w/o Control System
Replacing Motor
NOTE: Perform the work only when the material is soft (70 ° C/158 ° F,
depending on material); otherwise the coupling can not be turned.
1. Disconnect motor power cable.
2. Detach plug connector from motor controller.
3. Turn the coupling until the screws of the coupling half shells are more
easily accessible.
4. Release the screws of the coupling half shells on the motor side.
5. The released coupling halves can fall apart. Remove carefully to prevent
separation. Store the coupling halves and protect them from dust. They
will be needed again.
CAUTION: The bracket may not be slid back in the slot or unscrewed.
6. Unscrew motor from bracket (1).
7. If there is protective varnish on the shaft of the new motor, remove it.
8. Attach the coupling to the shaft without using force (no jolts or
pounding). If this is difficult or impossible, sand the pulley keys and shaft
with emery paper. Lubricate pulley keys and shaft if needed.
9. Install new motor in the bracket.
10. Attach coupling (Refer to
Important Regarding Coupling )
Fig. 7-5
11. Reconnect motor electrically.
12. Secure power cable with strain relief. Ensure that cable shield and
clamp have contact.
13. Verify that the motor is connected properly. The pump should turn
clockwise (See arrow).
Fig. 7-6 Direction of pump
rotation