Model SCH-1 Heater
30
1999 Nordson Corporation
All rights reserved
108 151D
Issued 8/99
Manual 12-11
See Figure 10.
Follow this procedure to assemble the fluid pressure
reservoir.
1. Install a new O-ring at the top of the fluid passage body.
2. Slide the high-pressure housing onto the fluid passage body high
enough to provide access to install the lower O-ring. If it is necessary
to use the tool kit, proceed as follows:
a. Install the hex stud (9) into the fluid passage body and tighten
securely.
b. Position the sleeve (8) on the base of the high-pressure housing.
c. Install the support (4) and the hex nut (7) onto the hex stud (9).
d. Rotate the hex nut (7) clockwise until the lower O-ring groove on
the fluid passage body is exposed.
e. Remove the hex nut (7), support (4), sleeve (8) and the hex
stud (9) from the heater.
3. Install the lower O-ring onto the fluid passage body.
4. Install the split retaining ring.
5. Slide the housing down on the split retaining ring.
6. Install the socket screw and washer into the fluid passage body and
tighten securely.
7. Install the fluid fittings in the fluid passage body and tighten securely.
8. Install the high-pressure fluid hose to the fluid inlet and outlet fittings.
Assembly
