Model SCH-1 Heater
28
1999 Nordson Corporation
All rights reserved
108 151D
Issued 8/99
Manual 12-11
Using the Disassembly Tool Kit
1.
See Figure 10.
Install the hex stud (9) on the base of the fluid
passage body and tighten securely.
2. Positional the sleeve (8) on the base of the high-pressure housing.
3. Install the support (4) and the hex nut (7) onto the hex stud.
4. Rotate the hex nut clockwise until the lower O-ring on the fluid
passage body is exposed. Remove the lower O-ring.
5. Remove the hex nut (7), support (4), sleeve (8) and hex stud (9) from
the heater.
6. Install the split clamps (2) using the hex screws (1) and tighten
securely.
7. Install the bolt (6) into the support (4).
8. Install the stud arms (3)
a. Install the upper end of the stud arms into the split clamps (2)
using hex nuts (5) and tighten securely.
b. Install the lower end of the stud arms into the support using the
hex nuts (5). Tighten the hex nuts evenly. This allows the
high-pressure housing to be removed from the fluid pressure body
without binding.
WARNING: To prevent injury from the tool kit hardware, use
extreme care when drawing down split clamps.
9. Install the bolt (6) into the fluid passage body. Rotate clockwise to
draw the split clamps down on the high-pressure housing. As the
high-pressure housing clears the fluid passage body top O-ring, the
high-pressure housing will be free to slide off the fluid passage body.
