Nordson 107 041A, Руководство пользователя

Страница: 43 / 166

Installation
3-9
E
1996 Nordson Corporation
All rights reserved
107 041A
Issued 1/96
Manual 12-28
7. Use the forklift to lift the oven off the pallet (4). Turn off the forklift and
lock the wheels and fork cylinders.
WARNING: Use extreme care when performing work below
heavy equipment. Failure to observe this warning may result in
personal injury, death, or equipment damage.
8. Get help to remove the pallet (4). Discard the pallet.
9. Remove the blower isolation frame retaining bolts (5). Do not remove
the blower isolation pads.
WARNING: Use extreme care when performing work below
heavy equipment. Failure to observe this warning may result in
personal injury, death, or equipment damage.
10. Screw in the blower isolation pads (11) and the oven leveling
pads (12).
Perform the following tasks to level the oven:
NOTE: The oven must be level whether part of an in-line system or as a
standalone unit. As part of an in-line system, both conveyor rails must
have the same pass line height as both up-line and down line equipment.
1. Turn on the forklift and unlock the fork cylinders.
2. See Figure 3-2 . Adjust the outer oven leveling pads (11) to
76.2 mm (3 in.).
3. Carefully lower the oven to the floor.
NOTE: Always place the leveling device on the top surface of the
oven near the cover sheet metal bend lines.
7. Moving the Oven into
Position
(contd.)
8. Leveling the Oven