START-S11
Technical manual
-4-
1.4
Type of electrical wires
Depending on the installation, the type and number of devices installed, the number of cables needed can
vary. The table below shows the cables needed for a typical installation. The cables used in the installation
must be IEC 60335 compliant.
1.5
Type of installation
It is important to make an important risk analysis of the “ MACHINE” and of the customers requirements in
order to decide how many products should be installed. All NOLOGO photocells dispose of a synchronisation
system which permit to avoid any interference between two couples of photocells (look the photocell’s
instructions for details)
In the diagram, photocells
“FOTO A”
in opening they have no effect, while it provoque a complete inversion
during closing.
“FOTO A2”
is the serial connection of
“FOTO A”
or
“ALT, FOTO B”
is the photocell working
by closing and opening.
Power supply line
Cable 3x1,5 mm
2
Motor cable (if not equipped)
Cable 4 x 1,5 mm
2
Flashing signal
Cable 2x1,5 mm
2
Electric lock
Cable 2x1,5 mm
2
Antenna
Shielded cable type RG58
key selector
Cable 3x0,5 o 0,75 mm
2
Photocell receiver
Cable 4x0,5 o 0,75 mm
2
Photocell transmitter
Cable 2x0,5 o 0,75 mm
2
Installation for sliding gates
Installations for swing gates
fOTO
A
fOTO
A2
