Nivus NivuLog Easy V3, Руководство пользователя

Страница: 46 / 141

4. First of all thread the connection cables of your sensors, actuators and, if necessary, the supply or
charging voltage through one of the two cable screw connections in accordance with the following
figure, and then through one of the two holes in the NivuLog Easy V3 base unit. Then connect the
cables to the connector plugs as described in chapter "Connecting the sensors, actuators and power
supply" on page 54. Depending on how flexible the cables are, it may be advantageous to connect
them to the connector plugs before the connector plugs are inserted in to the NivuLog Easy V3 base
unit.
Important note: Only a single cable must be threaded through the cable screw connections to
ensure the seal of the housing is not jeopardised.
Threading the connection cables in
1 Cable screw connection (cable diameter of 5-
10 mm) 3 Connector plug (2x 2-pin, 2x 3-pin, 1x 6-pin)
2 Connection cable of a sensor, actuator or the
supply or charging voltage
5. In accordance with the following figures, thread the engagement hook with the side that has the longer
lug first (see "Fig. 2 - preparing the cable screw connection" on page 45) through the hole in the
NivuLog Easy V3 base unit. The cables that have already been threaded in are not illustrated in this
figure in the interests of clarity.
Fig. 1 - threading in the cable screw
connection Fig. 2 - threading in the cable screw
connection Fig. 3 - threading in the cable screw
connection
46 of 141 NivuLog Easy V3 - Rev. 03 as of 24.10.2018