Nivus NivuLog Easy V3, Руководство пользователя

Страница: 13 / 141

Chapter 2 Safety instructions
2.6.2 Storage with inserted power supply unit
Activate the transport lock, by setting the "Operation mode" in the "Basic settings" configuration section (see
"Basic settings" on page 99) to "transport". You may need to initiate a transmission again to ensure the
changed configuration is transmitted to the device. Wait until the status LED goes out (see "2-colour status
LED" on page 73), i.e. the connection to the server has been terminated. With the "online" connection type,
the determined measurement data and changed "Operation mode" are immediately transmitted to the Device
to Web server. Then disconnect the device from the supply or charging voltage. If possible, switch off the
supply or charging voltage before disconnecting the cables from the V IN and GND clamps (see "Connecting
the sensors, actuators and power supply" on page 54). The remaining cables and antenna can then be
removed. Store the NivuLog Easy V3 in its original packaging.
By activating the transport lock, the NivuLog Easy V3 is placed in a very energy-saving mode. However, it
may still occur that the inserted power supply unit is fully discharged if the device is stored for very long
periods. Although the configuration and the most recently determined data are always retained. The system
time also continues to run thanks to the hardware real-time clock equipped with its own buffer battery. This
means that a valid time basis is available immediately following recommissioning (see "Technical details
about the system time" on page 67). The transport lock is deactivated again by re-initiating Aloha
transmission mode (see "Aloha transmission mode" on page 36) and the NivuLog Easy V3 resumes
operation according to the configuration.
2.7 Obligation of the operator
WARNING:
In the EEA (European Economic Area), the national implementation of the framework
directive (89/391/EEC) as well as the associated specific directives and from these in
particular, the directive (2009/104/EC) about the minimum safety and health requirements
for use of work equipment by workers at work, each in their respective version are to be
complied with.
The operator must obtain the local operating licence and the associated documents.
In addition, the operator must comply with the local legal requirements for
l
the safety of the personnel (accident prevention measures),
l
the safety of the equipment (protective equipment and maintenance),
l
the product disposal (waste disposal law),
l
the material disposal (waste disposal law),
l
the cleaning (cleaning agents and disposal) and
l
the environmental protection amendments.
Before commissioning, the operator must ensure that the installation and commissioning – provided these
were performed by the operator himself – are in compliance with the local regulations.
2.8 Personnel requirements
Installation, commissioning and maintenance may only be completed by personnel who meet the following
conditions:
l
Qualified specialist personnel with the relevant training
l
Authorised by the facility operator
NivuLog Easy V3 - Rev. 03 as of 24.10.2018 13 of 141