Parameter Setting
NFP - rev. 04 / 23.05.2018
page 39
Modifications concerning language, units and contrast do not require the code to be entered
as these settings influence just the way of representation and not measurement or output.
If parameter settings are not going to be modified but just verified by selecting each parame-
ter, there will also be no request at the end of the dialog.
Regard the measuring units
Please observe the bottom line of the display whilst programming, indicating the pre-
selected measuring unit.
Regard the options of the device type used
This instruction manual describes all programming options of the NFP. Depending on the
device type however there might be only one analog output available or the maximum pipe
diameter to set might be 450 mm (see Table 3).
After mounting and installing sensor and transmitter (see previous chapters) activate the
power supply.
On
initial start-up
the operating language needs to be selected:
Fig. 26-2
Language options for initial start-up
Use >up< and >down< arrow keys to choose the desired language and confirm with >Enter<.
The language can be changed later at any time by using the >EXTRA< / >Language< menu.
On
initial start-up
the screen below comes up:
1
Device version (25 or 28 resp. 25 - Ex or 28 - Ex) (see chapter “16.1 Device Types”)
2
Device software version No.
3
Device software version date
Fig. 26-3
Start screen
This screen will remain for a couple of seconds before the main display appears.
Содержание NFP
