Nivus NFP, Инструкция по эксплуатации

Страница: 34 / 87

Instruction Manual
NIVUS Full Pipe
page 34 NFP - rev. 04 / 23.05.2018
Initial start-up
21 Notes to the user
Required documentation
To put the entire system into operation it may be necessary to additionally consult the in-
struction manuals of the following accessories as well.

Installation Instruction for Correlation and Doppler Sensors

Technical Instructions for Correlation Sensors and external Electronic Box
These manuals are provided with the delivery of the accessories.
Before connecting and operating the transmitter the instructions below shall be followed.
This instruction manual contains all information required for the setting of parameters and for
the use of the instrument. The manual is intended for qualified personnel. Appropriate
knowledge in the areas of measurement systems, automation technology, control engineer-
ing, information technology and wastewater hydraulics are preconditions for putting the
transmitter into operation.
Read this instruction manual carefully in order to guarantee proper function of the transmitter.
The transmitter shall be wired according to chapter “20.5.1 Transmitter Connection”.
In case of doubt regarding installation, connection or the setting of parameters contact our
hotline:
•
+49 (0) 7262 9191 955
To put the entire system into operation additionally consult the instruction manuals of the fol-
lowing accessories as well. These manuals are provided with the delivery of the accessories.
22 General principles
The system shall not be put into operation before the installation has been finished and
checked. To exclude faulty programming this instruction manual must be read before the ini-
tial start-up. Please get familiar with the NFP programming via display and keyboard by read-
ing the instruction manual before you begin to program the device.
After transmitter and sensors are connected the parameters must be set. In most cases all
you need is:
•
inside pipe diameter
•
display units
•
span and function of analog and digital outputs
The NFP user surface was designed in a way that even unfamiliar users are able to easily set
up basic settings in graphic dialog mode which ensure reliable device operation.
For extensive programming, difficult hydraulic conditions, in case of absence of expert staff or
if a setup and error protocol is required, the programming should be carried out by the manu-
facturer or an expert company which is authorised by the manufacturer.