Nikon NPL-302 Series, Инструкция по эксплуатации

Страница: 40 / 234

2 Preparation
20 Pulse Laser Station NPL-302 Series Instruction Manual
Measurable distances may be shorter or measurement intervals may be longer in the
following cases:
• the angle of the laser against the target is small
• the surface of the target is wet
In direct sunlight, the measurable distance may be shorter. In this case, try to throw
a shadow on the target.
Targets with completely flat surfaces, such as mirrors, cannot be measured unless
the beam and the target are perpendicular to each other.
In the Reflectorless mode, the beam passing area
is shown by a circle in crosshairs on the
telescope reticle.
If the target is smaller than the circle and there is
something highly reflective in the background,
the measured data may be affected by these
adverse conditions.
When an obstacle momentarily passes through
the beam between the instrument and the target
(for example, passing cars on the road), the false data (short distance) is deleted
automatically. However, if the amount of reflection is almost the same and the
difference in distances between the correct and the false data is less than two meters,
it may cause an error in measurements.
Sighting a prism in Reflectorless mode may cause
an excessive signal error. In this case, change the
[MSR1]
or
[MSR2]
key
Target
setting to
Prism
.
Make sure there are no obstacles between the instrument and the target when
taking measurents.
When you need to take measurements across a road or a place where vehicles or
other objects are frequently moving, take several measurements to a target for the
best result.
Beam passing area