23
GB
7.8) Accessories
The following optional accessories are available for RUN:
• SMXI or SMXIS: Radio receiver at 433.92MHz with digital Rolling
Code encoding.
• ONEXI: Radio receiver at 433.92MHz with digital Rolling Code
encoding; equipped with Modo III to send 15 types of command
to control unit
• OperaView; Remote programming unit.
Consult the Nice S.p.a. product catalogue for the complete and
updated list of accessories.
Led 1
Description
• Function programming in progress.
• If flashing with L4 indicates need for device self-learning phase (see paragraph “4.3 Device self-learning”)
Led L6
Description
Led L5
Description
Led L3
Description
Led L2
Description
Led L4
Description
During normal operation indicates “Thrust” not active.
Off
Off
Table 23: leds on control unit keys
During normal operation indicates “Automatic closing” not active
During normal operation indicates “Automatic closing” active
• Function programming in progress
• If Flashing with L2 indicates need for device self-learning phase (see paragraph “4.3 Device self-learning”).
On
Flashing
Off
During normal operation indicates “Reclose after Photo” not active
During normal operation indicates “Reclose after Photo” active
• Function programming in progress.
• If flashing with L1, indicates need for device self-learning phase (see paragraph “4.3 Device self-learning”)
On
Flashing
Off
During normal operation indicates “Always close” not active.
During normal operation indicates “Always close” active.
During normal operation the device indicates “Stand-by” not active.
During normal operation the device indicates “Stand-by” active.
• Function programming in progress.
• If flashing with L3 indicates need for leaf length self-learning phase (refer to Paragraph “4.4 Leaf length
Self-learning”).
On
Flashing
Off
On
Flashing
During normal operation indicates “Thrust” active.
Function programming in progress.
On
Lampeggia
During normal operation indicates “Pre-flash” not active.
During normal operation indicates “Pre-flash” active.
Function programming in progress
Off
On
Flashing
Led L7
Description
During normal operation indicates that the CLOSE input activates a close manoeuvre
During normal operation indicates that the CLOSE input activates a partial opening manoeuvre.
Function programming in progress
Off
On
Flashing
Led L8
Description
During normal operation indicates that RUN is configured as Master
During normal operation indicates that RUN is configured as Slave
Function programming in progress
Off
On
Flashing
7.8.1) Remote programming unit
More specifically, connector BusT4.8 (see figure 30) enables con-
nection of the remote programming unit OperaView which enables
complete and rapid management of installation, maintenance and
troubleshooting of any malfunctions.
To access the connector, remote the membrane as shown in figure 31.
The remote programming unit can be placed at a distance from the
control unit, with up to 100m of cable; it can be connected simulta-
neously to up to 16 and can remain connected during normal oper-
ation of RUN; in this case a specific “user” menu enables delivery of
commands to the control unit.
If a ONEXI type radio receiver is inserted in the control unit, the
remote programming unit enables access to the parameters of the
memorised transmitters.
A 4-core cable is required for these functions (BusT4) while am 8-
core cable of maximum length 1m (BusT8) also enables updates of
the firmware of the RUN control unit.
Further information is available in the OperaView programmer
instruction manual
30
31
