New Leader AGCO NL5258G5, Руководство оператора

Страница: 19 / 142

- 19 -
NL5258G5/NL5300G5
www.New-Leader.com
(800) 363-1771 314732-AA-B
Header Safety Decals
SAFETY DECAL MAINTENANCE
Keep safety decals and signs clean and legible at all times.
Replace safety decals and signs that are missing or have become illegible.
Replaced parts that displayed a safety sign should also display the current sign.
Safety decals or signs are available from your dealer’s Parts Department or from Highway Equipment
Company by calling (800) 363-1771 .
SAFETY DECAL INSTALLATION
Clean Surface
Wash the installation surface with a synthetic, free-rinsing detergent. Avoid washing the surface with a
soap containing creams or lotion. Allow to dry.
Position Safety Decal
Decide on the exact position before application. Application marks may be made on the top or side
edge of the substrate with a lead pencil, marking pen, or small pieces of masking tape. NOTE: Do not
use chalk line, china marker, or grease pencil. Safety decals will not adhere to these.
Remove the Liner
A small bend at the corner or edge will cause the liner to separate from the decal. Pull the liner away in
a continuous motion at a 180-degree angle. If the liner is scored, bend at score and remove.
Apply Safety Decal
Tack decal in place with thumb pressure in upper corners. Using fi rm initial squeegee pressure, begin
at the center of the decal and work outward in all directions with overlapping strokes. NOTE:
Keep squeegee blade even—nicked edges will leave application bubbles. Pull up tack points before
squeegeeing over them to avoid wrinkles.
Remove Pre-mask
If safety decal has a pre-mask cover remove it at this time by pulling it away from the decal at a 180
degree angle. NOTE: It is important that the pre-mask covering is removed before the decal is
exposed to sunlight to avoid the pre-mask from permanently adhering to the decal.
Remove Air Pockets
Inspect the decal in the fl at areas for bubbles. To eliminate the bubbles, puncture the decal at one end
of the bubble with a pin (never a razor blade) and press out entrapped air with thumb moving toward
the puncture.
Re-Squeegee All Edges