Temperature reporting
Again as mention earlier, the sensor sends the current temperature data to the
coordinator of the network once every 3 minutes by default if not pairing settings were
done. The device sends captured temperature data to paired machine which installed
ZiG-BUTLER or any other ZigBee enabled in-home display device. For more details
about temperature reporting configuration, please refer to
temperature reporting
on
chatper
ZiG-BUTLER
of this manual.
Device Tampering
ZB11C comes with tampering alarm. Any attempt of unauthorized tampering such as
removing the device cover, the device sends alarm messages to the security system (CIE
device) to set off the siren in the network.
Overcoming a sleeping device
The ZB11C is featured to be an end device and is designed to enter temporal sleep after
idle to save battery power. Sometimes during system setup you would want to retrieve
information (i.e. IEEE address, short address) from the device so you need to press keys
to allow the device to enter wake mode to stay connected.
Operation:
Press auxiliary key once, the green indicator will give
5 short flashes
. The
device will be active and will broadcast its short address and its device physical IEEE
address.
Low Battery Notification
When ZB11C uses battery to power, the device will not work if the battery is bellow
3.3Vdc.
The green indicator will flash once and the device will broadcast low battery message to
the network notifying the user for battery replacement.
Restore to factory setting
ZB11C is capable of storing and saving includes network routing information. If you wish
to remove ZB11C from an exited network, you would need to clear the saved routing and
