NetApp HCI, Руководство пользователя

Страница: 329 / 363

ii. Select Teaming and failover , and select the Override checkbox.
iii. Move vmnic4 to Standby adapters by using the arrow icon.
iv. Select OK .
i. With vSwitch1 selected, from the Actions drop-down menu, select Add Networking and enter the
following details in the window that is displayed:
i. For connection type, select VMkernel Network Adapter , and select Next .
ii. For target device, select the option to add a new standard switch, and select Next .
iii. Select + .
iv. In the Add Physical Adapters to Switch window, select vmnic1 and vmnic5, and select
OK .
vmnic1 and vmnic5 are now listed under Active adapters.
v. Select Next .
vi. Under port properties, change the network label to iSCSI-B, and select Next .
vii. Under IPv4 settings, provide the IPv4 information, and select
Next .
The IP address you enter here is the iSCSI-B IP address that you copied earlier.
viii. If you are ready to proceed, select
Finish .
vSwitch2 is displayed in the list of virtual switches.
j. Select vSwitch2 , and select the pencil icon to edit the settings as follows:
i. Under Properties, set MTU to 9000, and select OK .
k. In the graphic that is displayed, select iSCSI-B , and select the pencil icon to edit the settings as
follows:
i. Select Security , and make the following selections:
ii. Select Teaming and failover , and select the Override checkbox.
iii. Move vmnic1 to Unused adapters by using the arrow icon.
iv. Select OK .
l. From the Actions drop-down menu, select Add Networking and enter the following details in the