NetApp HCI, Руководство пользователя

Страница: 322 / 363

a. Read the VMware End User License Agreement.
b. If you accept the terms, select I accept at the end of the agreement text.
7. Select Continue .
8. On the vCenter page, perform the following steps:
a. Enter a FQDN or IP address and administrator credentials for the vCenter instance associated with
your NetApp HCI installation.
b. Select Continue .
c. Select an existing vSphere datacenter to which to add the new compute node, or select Create New
Datacenter to add the new compute nodes to a new datacenter.

If you select Create New Datacenter, the Cluster field is automatically populated.
d. If you selected an existing datacenter, select a vSphere cluster with which the new compute nodes
should be associated.

If NetApp HCI cannot recognize the network settings of the cluster you have
selected, ensure that the vmkernel and vmnic mapping for the management, storage,
and vMotion networks are set to the deployment defaults.
e. Select Continue .
9. On the ESXi Credentials page, enter an ESXi root password for the compute node or nodes you are
adding.
You should use the same password that was created during the initial NetApp HCI deployment.
10. Select Continue .
11. If you created a new vSphere datacenter cluster, on the Network Topology page, select a network topology
to match the new compute nodes you are adding.

You can only select the two-cable option if your compute nodes are using the two-cable
topology and the existing NetApp HCI deployment is configured with VLAN IDs.
12. On the Available Inventory page, select the node you want to add to the existing NetApp HCI installation.

For some compute nodes, you might need to enable EVC at the highest level your
vCenter version supports before you can add them to your installation. You should use
the vSphere client to enable EVC for these compute nodes. After you enable it, refresh
the
Inventory page and try adding the compute nodes again.
13. Select Continue .
14. Optional: If you created a new vSphere datacenter cluster, on the Network Settings page, import network
information from an existing NetApp HCI deployment by selecting the Copy Setting from an Existing
Cluster checkbox.
This populates the default gateway and subnet information for each network.
15. On the Network Settings page, some of the network information has been detected from the initial
deployment. The new compute node is listed by serial number, and you should assign new network
information to it. For the new compute node, perform the following steps:
a. If NetApp HCI detected a naming prefix, copy it from the Detected Naming Prefix field, and insert it as
the prefix for the new unique hostname you add in the Hostname field.