December 2004
NEC Business Solutions Ltd
526 – Chapter 1
DRAFT 3
Section 5, Function Timer Chart
Doc. No.: 81
94 - Release 2.0
December 2004
Tie Line Length of
Delay Signal
Selection
3-22
Specify the time a delay pulse is
sent to another system.
0 ms.
300 ms.
4500 ms.
Tie Line Incoming
Interdigit Timeout
Selection
3-24
Specify the maximum time during
the incoming call detection
process. If an address signal is not
received within a specified time,
an error tone is returned to the
other system.
1 sec.
6 sec.
No Limit
Tie Line Wink/Delay
Signal Detect
Timeout Selection
3-25
Specify the maximum time for
receiving an acknowledgment
signal from a distant system
before sending a busy tone.
1 sec.
7 sec.
No Limit
Disconnect
Recognition Time
Selection
3-33
Specify a minimum time for a
disconnected circuit to be
accessed again.
0 sec.
0.3 sec
1.5 sec.
DIT Delay Answer
Timer Selection
3-61
This Memory Block is used to
specify the time and incoming CO/
PBX call will ring before changing
to DIT.
0 sec.
5 sec.
60 sec.
Table 1-3:
Function Timer Chart (Continued)
Timer
Memory
Block
Definition
Timing Value
Minimum
Default
Maximum
