3-44, Caller ID Display Assignment for CO/PBX Line
DRAFT 3
Chapter 1 – 383
Xen IPK
Programming Manual
Doc. No
.: 8194 -
Rele
ase 2.
0
December
2004
System Mode
3
Submode
—
Data No.
44
PC Programming
+ BCT
Caller ID Display Assignment
for CO/PBX Line
General Description
Use this Memory Block to assign one Multiline Terminal, per CO/PBX, line to display Caller ID
Indication on incoming CO/PBX calls.
Display
Programming Procedures
1
Go off-line.
2
Press LK3 +
N
+
DD
to access the Memory Block.
3
Enter data using the dial pad.
Note:
The following are used when entering data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data
Default Values
Not Specified
4
Press
N
to write the data.
5
Press
P
to go back on-line.
Related Programming
M.B. Number
Memory Block Name
Refer to
Chapter 2, Guide to Feature Programming.
N
To display Caller ID Indication for normal incoming CO calls and CAR incoming calls, both Caller ID Indication and Ring
assignment must be assigned for the terminal in System Programming. A maximum of 15 Multiline Terminals can be
assigned system-wide to display caller identification for normal incoming CO calls and CAR incoming calls using Memory
Block , 1-1-78 , Caller ID Display Assignment for System Mode. A third Multiline Terminal can be assigned to display
caller identification for normal incoming CO calls, per CO line, using this Memory Block.
0 1 / 4 4 : C A L L I D
0 0
T I M E
D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Tel
Port No.
01~C0
Title
