Configuration Procedures
5-11
settings. To create a new partition
1. Navigate to the partitioning page of the remote console interface for the system.
2. Click
Create new partition
.
3. Select the boot cell from the list.
4. Type the partition name, which can have up to 16 characters including letters,
numbers, and spaces.
5. Select one of the following options:
y
Obtain an IP address automatically (use DHCP)
y
Use the following settings
6. If you selected
Use the following settings
, type values for the following
parameters:
y
IP
address
y
Subnet
mask
y
Gateway
7. Click
Submit
.
The partition appears in the table with the boot cell as a member.
8. Move additional cells into the new partition, if desired, using the procedure in
5.3.4
Moving Cells to Other Partitions
.
5.3.4.
Moving Cells to Other Partitions
You can move cells to a partition only if the cell you want to move is not running in
another partition. This procedure establishes the partition membership. To move cells to
an existing partition
1. Navigate to the partitioning page of the remote console interface for the system.
2. Click
Move cells between partitions
.
3. For each partition, select a cell that you want to include in the partition membership.
The partition boot cell is selected when a partition is created. Refer to the
User’s
Guide
.
Note: If you move the boot cell for one partition to another partition, you must select
a different boot cell for the first partition; refer to the User’s Guide.
4. Click
Submit
.
If the management firmware level on the cell is different from the level on the
partition, a dialog box appears.
5. Click
OK
to proceed with updating the firmware automatically on the cell for the
Содержание NECCare Platinum Express5800/A1160
Страница 1: ...EXPRESS5800 A1160 Service Processor Troubleshooting Guide...
Страница 10: ......
Страница 52: ...456 01807 000...