NEC Express 5800/120Lh, Руководство пользователя, Страница: 196 / 314

8-22 Troubleshooting
The system does not restart automatically when a stop error occurs, though the system is
adjusted to automatically restarting:
→
When the system does not restart automatically, restart it manually.
The system restarts automatically when a stop error occurs, though the system is NOT
adjusted to automatically restarting:
→
There is no problem about this issue.
Check the System Event Log to confirm that STOP error occurred.
Cannot turn the power OFF at the blue screen:
→
If you want to turn off the power at the blue screen, execute forced shutdown
(forced shutdown: continue to press POWER switch for 4 seconds). The power
will not be turned off if you press the switch for less than 3 seconds.
The server is not found on the network:
T
Is the LAN cable connected?
→
Make sure to connect the LAN cable to the network port on the rear of the server.
Also make sure that the LAN cable to use conforms to the network interface
standard.
T
Is BIOS configuration correct?
→
The internal LAN controller may be disabled with the BIOS SETUP utility of the
server. Check the setting with the BIOS SETUP utility.
<Menus to check:
[Advanced] - [PCI Configuration] - [Embedded NIC (Dual Gbit)]>
T
Have the protocol and service already configured?
→
Install the distinctive network driver for the server. Make sure that the protocol,
such as TCP/IP, and services are properly specified.
T
Is the transfer speed correct?
→
Open the network property dialog box in control panel to specify the "Link Speed
& Duplex" value the same as the value specified for HUB.