Is off
No external power supply
GSM INDICATOR
Description of modes
Is constantly on
The connection to the server has been established
Flashes once per second
Initialization of the GSM module
Flashes 2 times per second
No connection to the server
Is off
SIM-cards are not installed/the channel is disabled
GNSS INDICATOR
Description of modes
Is constantly on
The location data are valid
Flashes once per second
Initialization of the satellite receiver
Flashes 2 times per second
Satellites are captured, but the location data are not valid
Is off
Short circuit of the antenna, there is no communication
with the reception.
CPU INDICATOR
Description of modes
Is constantly on
Normal working mode of the device
Flashes once per second
No external power supply, powered by the battery
Flashes 2 times per second
Loader mode
Is off
Connected via USB to a computer
WiFi INDICATOR
Description of modes
Is constantly on
Connected to the access point, there id Internet access
Flashes once per second
Connecting to an access point
Flashes 2 times per second
Searching for an access point, can not find any
Is off
WiFi is disabled
IR/SAT INDICATOR
Description of modes
Is constantly on
Data are being transmitted via a satellite
Flashes once per second
Initialization of the satellite channel
Flashes 2 times per second – for no longer
than 2 sec.
There was a data communication error
Is off
Satellite modem is off
5.5. CONNECTION of the SENSORS and PERIPHERALS
The most common types of connections are given in the following table.
Type of the connected
peripherals
Description of the connection
What contacts are used
Alarm button,
Ignition control,
Program counter,
Engine hour indicator,
Call of the dispatcher,
Arming,
Control of lights,
The presence of the driver,
Safety belt,
ABS trigger,
SRS trigger,
The door is open,
Smoking of the saloon,
The alarm went off
To any IN ... IN8 input. the desired input
function is selected in the configurator in
the function selection menu.
a sensor with the corresponding
parameter should be created in the
monitoring program.
RS485 fuel sender,
Other peripherals
Connected to the A1 and B1 contacts
(Port1). A detailed description of the
connection is given in the manual for the
plug-in peripherals.
+12V
GND
In1
In2
In3
In4
In5
In6
In7
In8
1-W
SPK
OUT
Tx1
Rx1
A1
B1
Tx2
Rx2
CAN
(H)
CAN
(L)
OUT1
(IN9)
OUT2
(IN10)
OUT3
(IN11)
OUT4
(IN12)
+12V
GND
In1
In2
In3
In4
In5
In6
In7
In8
1-W
SPK
OUT
Tx1
Rx1
A1
B1
Tx2
Rx2
CAN
(H)
CAN
(L)
OUT1
(IN9)
OUT2
(IN10)
OUT3
(IN11)
OUT4
(IN12)
