![background image](http://html2.mh-extra.com/html/namco/tekken-4/tekken-4_operation-manual_3168016041.webp)
6. ADJUSTMENT FOR OPERATION
6-2-4 INTERLACE CHECK (switching between interlace and non-interlace
modes)
‘Only when monitor’s horizontal synchronization frequency is 15.75
Interlace mode:
This mode provides more detailed and smoother graphics than the
non-interlace mode. By shifting the picture display position a half
line in the vertical direction once the twice
operations, it
doubles the vertical resolution without changing the
frequency.
l
are compatible with the interlace
mode.
Non-interlace mode: Use this display mode when interlace mode results in flicker over
the entire screen display. In the non-interface mode, there is no
shift of the display position, and the display remains consistent
ery time.
Follow steps and in ‘6-2-i Common procedures” 33 and P. 34) to display
the Interlace Check screen.
If the Display
Test screen is already displayed, skip the
in common
p r o c e d u r e s .
DISPLAY TEST
Interlace
Previous Color
:
EXIT color edit
:
:
:
l
If the Interlace
Check screen is not shown, press the Button switch 1
repeatedly until the
Interlace Check screen appears.
Every time the Button switch 1 is pressed,
the screen changes in the
following order: COLOR
CONVERGENCE INTERLACE CHECK
If the Color Edit screen is not shown, press the PI Button switch 3. The
Color Edit screen is displayed on top of the Interlace Check screen.
* The Color Edit screen appears and disappears alternately each time the
Pi Button switch 3 is pressed.
Button switch
Button switch 3
(Note] The above diagram shows a pair control panel. For a single contra)
panel (when two
STANDARD (JVS) conforming cabinet
cabinets are connected for communication-linked setup), the cabinet
installed with the PC board is the unit.