![background image](http://html2.mh-extra.com/html/namco/tekken-4/tekken-4_operation-manual_3168016045.webp)
6. ADJUSTMENT FOR OPERATION
Operate the lever or switch according to the test and adjustment item shown in the
following
table,
and make the adjustment.
Item
Sound output test
Monaural/stereo
setting
Test/adjustment
Operation
Reproduction of test
sound
When PI Button switch 1 is pressed, sound i
produced from the left, then
the right,
followed by stereo test sound from both
speakers.
Switching between
monaural and stereo setting changes between monaural and
If the test shows
an
abnormality, refer to 52
Troubleshooting.”
To return to the test menu screen, press the Start switch.
PI
Button switch 1
Start switch
(Note) The above diagram shows a pair control panel.
For a single control
panel (when
two
STANDARD (JVS) conforming cabinet
cabinets are connected for communication-linked setup), the cabinet
installed with the PC board is the PI unit.
To exit from the test mode, follow the procedures described in “6-l-3 Exiting from
test mode” 30).
6-5 JVS STATUS (display of status of
VIDEO STAN-
DARD (JVS) conforming cabinet)
This screen displays the status of the
VIDEO STANDARD (JVS) conform-
ing cabinet.
l
When the PC board is connected to a
STANDARD conforming
cabinet, this item cannot be used even if it
is shown on the screen.
Follow steps through in
Selection of adjustment item” (P. 30 and
31). In step
select “JVS STATUS.”
The screen will show the status of the
VIDEO STANDARD (JVS) conform-
ing cabinet.
Press the PI Start switch to return to the test menu screen.
To exit from the test mode, follow the procedures described in
Exiting
from
test mode”
32).