![background image](http://html1.mh-extra.com/html/nabco/gt20/gt20_programming-manual_3092584027.webp)
Rev. 10-7-16
Part #C-00140
GT20 Control Wiring and Programming Manual
Initial Setup Procedure
6-25
27.►Move the Joystick Down to until the Element Inverse OFF is displayed.
Invers
OFF
28.►Briefly push down on the Joystick. The Value will start to blink on the lower half of the screen.
29.►Move the Joystick to the Right or to the Left to select(1) of the following Values ON or OFF.
30.►Briefly push down on the Joystick to (OK) selection. Move the Joystick Down until the Element
TEACH is displayed.
TEACH
Clear the area of any persons or objects in the path of moving Door Panel, in order to
avoid injuries or damages.
31.►Ensure the Door Panel is fully closed.
32.►Briefly push down on the Joystick. The Element Teach OK? will be displayed.
TEACH
ok?
33.►Briefly push down on the Joystick to (OK) selection.
a. The setup procedure (Teach) will begin.
b. The GT20 Control will start to beep with each second it takes for the Setup Procedure to
complete the programming process (9 - 0).
c. After countdown, the Door Panel will OPEN to the (Ao) Open Position or to the Open Door Stop
position (whichever comes first), and then CLOSE.
d. If the Door Panel opens much wider than the (Ao) angle programmed within the GT20 Control,
the angle can be corrected by changing the dAxis Value. If the Door Panel continues to open at a
much greater angle (Ao):
X
Ensure that the Swing Door was installed using the correct measurements.
X
Check the Swing Arm length, and the Swing Arm location on the Door Panel, and the Output
Spindle location.
e. Upon completion of TEACH, the LCD screen will display the Home Page (Display will vary):
>##<
EO1
34.►Go to the Program Selection Switch.
35.►Ensure the area is clear from any persons or objects in path of moving Door Panel.
36.►Select the Door Open Icon.
37.► The Door Panel will fully Open and then fully Close.
Note: Approximately every 24 hours, the GT20 Control will perform a UL required motor test. This test only
happens during a normal activation cycle that has been initiated by a user. Once a day, after the door
has been activated, the door will fully open then time out and begin to close normally. While the door is
closing, about ½ way through the cycle, the control will bring the door to an abrupt stop for about three
seconds then it will continue to allow the door to close. As previously stated this is a normal procedure
required by UL and is completed once a day by the GT20.
WARNING
Содержание GT20
Страница 2: ...THIS PAGE IS INTENTIONALLY LEFT BLANK...