MUTOH Rockhopper II 2H, Руководство по обслуживанию

Страница: 112 / 319

Rockhopper II series printers – Maintenance Manual
113 AP-74065, Rev. 1.2, 27/09/04
Step 8 :
Remove the connector and tube from the maintenance assembly.
1 = tube connections
Notes :
¾ There is some remaining ink in the tubes. Be careful that the ink is not spilled from
the tube onto the printer or items close to the printer.
Step 9 :
Remove the 6 screws fixing the maintenance assembly.
1 = Waste fluid receptacle 2 = Maintenance assembly
3 = Screws (M3x8) fixing the maintenance assembly
Step 10 :
Replace the maintenance assembly.
Notes :
¾ Secure the maintenance assembly so that it abuts against the rear right portion.
¾
If the cap tube has not been cut, cut it to the length below, measured from the end
of the tube: Numbers in brackets ( ) are the cap numbers from left to right as viewed
from the front of the main body. For 50, 64 inch model: (1) 50mm, (2) 0mm, (3)
40mm, (4) 0mm For 87 inch model: (1) 90mm, (2) 50mm, (3) 40mm, (4) 70mm,
(5) 0mm, (6) 30mm, (7) 30mm, (8) 0mm
¾ The connection sequence for the tubes is as follows: Numbers in brackets ( ) are
the cap numbers from left to right as viewed from the front of the main body.