MUTOH Rockhopper II 2H, Руководство по обслуживанию

Страница: 212 / 319

Rockhopper II series printers – Maintenance Manual
213 AP-74065, Rev. 1.2, 27/09/04
7.3.2. Procedure for creating backup parameters
This section explains the procedure for recording backup parameters from the Mainboard assembly onto a
memory card.
Use the following procedure to create backup parameters.
Important :
¾ Before replacing parts, be sure to perform the following operations.
ƒ Turn the machine power OFF.
ƒ Remove the product's electrical plug from the socket. Otherwise, you
may suffer electric shock or the machine’s electric circuits may be
damaged.
¾ Disconnect all cables from the machine. Not doing so could cause damage to
the printer.
Step 1 :
Remove the memory cover.
Step 2 :
Install the memory card for parameter backup into the memory card connector slot (J104) on the
mainboard assembly.
Notes :
¾
Install the memory card so that its front is toward the inside of the printer.
Step 3 :
Turn the power to the printer on.
¾ After all of the lamps on the operation panel light up, the LED display on the panel displays
"PRINTER
→
CARD".
Step 4 :
Press the [ENTER] key on the operation panel.
¾ The LED display on the operation panel displays "P
→
C Started".
¾ Backup parameter creation begins.
Step 5 :
If the backup parameter has been created correctly, "P
→
C Completed" is displayed on the
operation panel.
Step 6 :
Turn off the power source to the printer.
Step 7 :
Remove the memory card for parameter backup.
Notes :
¾ If you do not have backup memory card, output "Adj. Variable" in "Sample Printing
Menu". Required parameter is output.
¾ For the panel setting value, output "Setup" in the Operation Manual. Maintenance
history is not printed.