Rockhopper II series printers – Maintenance Manual
169
AP-74065, Rev. 1.2, 27/09/04
5.5.9. P_REAR sensor position adjustment menu
Adjust the P_REAR sensor position in order to accurately detect the length of the cut media.
During this adjustment, the P_REAR sensor position can be adjusted inside the firmware by referring to the
nozzle, in order to obtain a maximum printable area starting from the ends of the media.
Make adjustments following the steps below.
Step 1 :
Set media as necessary.
Notes :
¾
Use cutting media for adjusting the P_REAR sensor. Set A3 cutting media in
portrait orientation.
¾
P_REAR sensor position adjustment is a process necessary during manufacturing.
This does not need to be done when band feed is compensated.
Step 2 :
After the media has been set, a pattern printing with the P_REAR sensor position adjustment is
performed.
The following is the description of the printing method.
¾
Draws a horizontal line (black 1 dot line) 17 mm away from the media end.
Step 3 :
Measure the distance from the media end to the line just drawn.
Содержание Rockhopper II 2H
