Multitech ProxyServer MTPSR1-202ST, Руководство пользователя, Страница: 116 / 142

ProxyServer User Guide
116
MTPSR1-202ST
S-Register: S2
Function: Escape Character
Unit: Decimal ASCII code
Range: 0–127
Default: 43 (+)
Description: S2 specifies the character used by the ProxyServer to escape from data mode and
return to command mode.
S-Register: S3
Function: Carriage Return Character
Unit: Decimal ASCII code
Range: 0–127
Default: 13 (^M)
Description: S3 specifies the character used by the ProxyServer to indicate the end of a
command line.
S-Register: S4
Function: Line Feed Character
Unit: Decimal ASCII code
Range: 0–127
Default: 10 (^J)
Description: S4 specifies the character used by the ProxyServer to indicate the end of a status
message.
S-Register: S5
Function: Backspace Character
Unit: Decimal ASCII code
Range: 0–32, 127
Default: 8 (^H)
Description: S5 specifies the character used by the ProxyServer to delete the previous character
in the command line.
S-Register: S7
Function: Wait for Connection (Abort Timer)
Unit: 1 second
Range: 0–255
Default: 45
Description: S7 sets the Abort Timer delay time, which is the length of time the ProxyServer waits
for a connection after dialing. If no connection is established during the specified
time, the ProxyServer ends the call.
S-Register: S10
Function: DCD Drop Time
Unit: 50 ms
Range: 0–254, 255
Default: 20
Description: S10 sets the time after a carrier signal is lost before the ProxyServer disconnects.
(The &C2 command must be in effect.) The default setting is one second. Maximum
delay is 25.4 seconds (S10=254). Set S10 to 255 to cause the ProxyServer not to
disconnect with loss of carrier.
S-Register: S25
Function: DTR Drop Time
Unit: 100 ms
Range: 0, 1–255
Default: 5
Description: S25 sets the time that DTR must remain low before the ProxyServer disconnects.
The S25 unit value for 0 is 50 ms. For values from 1 through 255, the unit value is
100 ms.