OnCell G3111/G3151-HSPA Series
Configuring Serial Port Operation Modes
7-8
RFC2217 Mode
TCP alive check time
(default=7 min): This field specifies how long the OnCell G3111/G3151-HSPA will wait
for a response to “keep alive” packets before closing the TCP connection. The OnCell G3111/G3151-HSPA
checks connection status by sending periodic “keep alive” packets. If the remote host does not respond to the
packet within the time specified in this field, the OnCell G3111/G3151-HSPA will force the existing TCP
connection to close. For socket and device control modes, the OnCell G3111/G3151-HSPA will listen for another
TCP connection from another host after closing the connection. If
TCP alive check time
is set to
0,
the TCP
connection will remain open even if there is no response to the “keep alive” packets.
TCP port
(default=4001): This is the TCP port number assignment for the serial port on the OnCell
G3111/G3151-HSPA. It is the port number that the serial port uses to listen to connections, and that other
devices must use to contact the serial port. To avoid conflicts with well known TCP ports, the default is set to
4001.
Packet length
(default=0): The Packet length setting refers to the maximum amount of data that is allowed
to accumulate in the serial port buffer before sending. At the default of 0 for packet length, no maximum
amount is specified and data in the buffer will be sent as specified by the delimiter settings or when the buffer
is full. When a packet length between 1 and 1024 bytes is specified, data in the buffer will be sent as soon it
reaches the specified length.
Delimiter 1 and Delimiter 2
(default=None): When Delimiter 1 is enabled, the serial port will clear the buffer
and send the data to the Ethernet port when a specific character, entered in hex format, is received. A second
delimiter character may be enabled and specified in the Delimiter 2 field, so that both characters act as the
delimiter to indicate when data should be sent.
ATTENTION
In order to enable a delimiter, packet length must be set to 0. Delimiter 2 should only be enabled in conjunction
with Delimiter 1 and never on its own; otherwise there may be data errors. Even when a delimiter is enabled,
the OnCell G3111/G3151-HSPA will still pack and send the data when the amount of data exceeds 1 KB.
Delimiter process
(default=Do Nothing): The Delimiter process field determines how the data is handled
when a delimiter is received. Delimiter 1 must be enabled for this field to have effect. If Delimiters 1 and 2 are
both enabled, both characters must be received for the delimiter process to take place.
•
Do Nothing:
Data in the buffer will be transmitted when the delimiter is received.
•
Del 1:
Data in the buffer will be transmitted after 1 additional byte is received following the
delimiter.
•
Del 2:
Data in the buffer will be transmitted after 2 additional bytes are received following the
delimiter.
•
Strip Delimiter:
Data in the buffer is first stripped of the delimiter before being transmitted.
Содержание OnCell G3111-HSPA series
Страница 11: ...OnCell G3111 G3151 HSPA Series Getting Started 2 2 Panel Layout OnCell G3111 G3151 HSPA...
Страница 82: ...OnCell G3111 G3151 HSPA Series System Management Settings 9 18...
Страница 116: ...OnCell G3111 G3151 HSPA Series Pinouts and Cable Wiring C 3 Pin Assignments for DB25 Male and Female Connectors...
