OnCell G3111/G3151-HSPA Series
Initial IP Address Configuration
3-7
4.
The Property window opens automatically. Select the
Communication Parameter
tab, and then select
the appropriate COM port for the connection (COM4 in this example). Configure the parameters for
115200,
8, N, 1
(
115200
for Baudrate,
8
for Data Bits,
None
for Parity, and
1
for Stop Bits).
5.
From the Property window’s Terminal page, select
ANSI
or
VT100
for
Terminal Type
and then click
OK
.
6.
If you are using the OnCell G3111/G3151-HSPA, you may power it up at this point and hold down the “grave
accent key” (`) while powering it up, as shown below. Note that the grave accent key (sometimes called
“backwards apostrophe”) is NOT the apostrophe key—it is the key usually found next to the number
1
key.
7.
If the OnCell G3111/G3151-HSPA has been set up for password protection, you will be prompted to enter
the password. After you enter the password, or if password protection was not enabled, you will be
prompted to select the terminal mode. Press
1
for
ansi/vt100
and then press
ENTER
.
-HSPA
Содержание OnCell G3111-HSPA series
Страница 11: ...OnCell G3111 G3151 HSPA Series Getting Started 2 2 Panel Layout OnCell G3111 G3151 HSPA...
Страница 82: ...OnCell G3111 G3151 HSPA Series System Management Settings 9 18...
Страница 116: ...OnCell G3111 G3151 HSPA Series Pinouts and Cable Wiring C 3 Pin Assignments for DB25 Male and Female Connectors...
