25/60
ST_PM_ Installation Manual_EN_V1.0 | 08.2020
Copyright © 2020 Mounting Systems GmbH
6.5.2.4
Mounting the spindle holder tube on spindle
Depending on the variant supplied for the project, the spindle holder can be assembled
as shown below on the threaded spindle at the centre.
Figure 12 Installing the spindle holder; single part spindle holder (left) OR split 2-part spindle holder (right)
1
Threaded spindle
4 Spindle Holder (Plastic)
2
Fixings
5 Retaining clamp
3
Spindle holder tube
•
Slide the spindle holder (4) into the retaining clamp (5) and press both parts by
gently bending them around the non-threaded part of the threaded spindle (1)
•
Spindle holder tube (3) should be centrally aligned with the threaded spindle (1)
•
The mounting flange of the spindle holder tube (3) must be between the
connection lugs of the plastic part (4) for single spindle plastic holder and as
shown in figure above on the left
•
In case of 2-part plastic spindle holder, the mounting flange of the spindle holder
tube (3) must be between the connection lugs of the retaining clamp (5) as shown
in the figure above on the right
•
Fasten all parts as shown using the hexagon screw M6x25 mm and a tightening
torque of 7 Nm
