Motortech VariStep3, Руководство по эксплуатации

Страница: 47 / 92

8 Settings via the MICT
Rev. 08/2018 47
8.7 Access Control of the Stepper Motor Driver
If the access control to the stepper motor driver is activated, access to the following areas is
possible with a PIN only:
– Troubleshooting
– Position changes (open, closed, position 1 and 2, manual adjustment, reference run)
– Configuration (transfer of a configuration to the stepper motor driver)
The access control regulates the accesses to the stepper motor driver via the MICT. For
explanations concerning access control of the stepper motor driver and the delimitation of the
access levels in the MICT, refer to section
Access Control on page 38.
The access control functions can be accessed in the menu bar via:
Device -> Access Control
8.7.1 Enable/Disable Access Control
Enable/Disable access control
As a default setting, the access control is not activated, and all PINs are set
to
0000 . Once the access control has been activated, and the PINs were
changed, these PINs will continue to be used. To activate the access control
again, you will need the PIN for level 3 (
Master ). It is therefore
recommended to reset all PINs before disabling.
If that was not done, or a system must be unlocked for another reason, a
request key can be issued in the MICT. Refer to the section
Reset all PINs on
page 48.
To enable or disable the access control, proceed as follows:
1. Open the input dialog via Device -> Access Control -> Enable or Disable access control .
2. Enter the PIN for the level Master (Level 3) .
3. Confirm the input with OK.
8.7.2 Login/Logout
If the access control is activated, you are prompted to log in if you want to execute functions that
are allocated to a specific operating level. In addition, you can log in specifically to an operating
level via the menu bar.
To log into a specific operating level, proceed as follows:
1. Open the input dialog via Device-> Access Control -> Login .
2. First select the level you wish to log on to.