Motortech VariStep3, Руководство по эксплуатации

Страница: 22 / 92

4 Product Description
22 Rev. 08/2018
Designation Function
Manual/Auto (switch) Switch for changing between manual and automatic operation (see
Manual and Automatic Operation on page 36)
Open/Close;
Reset In manual mode the stepper motor can be driven via the buttons
Open and Close (see Manual and Automatic Operation on page 36).
In the case of an error, the error can be reset followed by a
reference run if you press the two buttons simultaneously.
The Open LED and the Close LED are flashing when the stepper
motor is moved into the corresponding direction via the buttons.
When a stop has been reached, the corresponding LED lights up
permanently.
Status You can find details about status signaling in the following
information box.
The LED flashes:
–
green: The stepper motor driver is working properly.
–
Orange: A warning occurred.
–
red: An error occurred.
For additional information on warnings and errors, read section
Runtime Data – Message Log on page 66.
Manual/Auto (LED) The LED lights up:
– green: The stepper motor driver is in automatic mode and is
controlled by the master control.
– Orange: The stepper motor driver is in manual mode.
USB Port for data transmission to the PC. Data transmission is signaled
by the LEDs blinking.
CAN Port for communication via CAN bus with master control. Data
transmission is signaled by the LEDs blinking.
RS485 Port for communication via Modbus with superordinate control
devices. Data transmission is signaled by the LEDs blinking.
Stepper Motor +
Encoder Port for the stepper motor and the encoder. LEDs A , B and I are
flashing when the stepper motor is moving (see Wiring Stepper
Motor and Encoder on page 28).
Power Connection for the supply voltage (see Wiring Power Supply on
page 27). This LED lights up if the supply voltage is available.