Motorola 68390 - Vanguard 320 Router, Руководство по установке

Страница: 57 / 106

Powering on the Vanguard 320 3-7
Accessing the Control Terminal Port
Accessing the Control Terminal Port
Introduction
Once you have powered on the Vanguard 320, you can access the Control Terminal
Port from the PC or terminal attached to the CTP port.
Note
Ensure that the dip switch 4 is in the DOWN position. Refer to “Front Panel Dip
Switches” section on page 2-12.
Note
This section does not provide all information about accessing the CTP. For more
information on accessing and using the CTP refer to the
Vanguard Basic
Configuration Manual (Part Number T0113).
Procedure
Follow these steps to access the Vanguard 320 CTP Main menu:
Note
This procedure assumes that a PC or terminal is connected to the Vanguard 320
using the CTP access cable.
CTP Access Via
Remote Telnet
Another way to connect to the CTP, after the node is configured and operational, is to
access remotely via your established IP network by telneting into the node from an
IP network-based personal computer or workstation. You can connect to the CTP by
entering
atds0 <CR>
after the Vanguard 320 outputs the OK prompt.
CTP Access Via
Remote X.25 or
Frame Relay
Network
If the Vanguard 320 is operating in an X.25 network, or if Frame Relay Annex-G is
used to connect with other Vanguard Managed Solutions nodes, you can access the
Vanguard CTP remotely by making a Switched Virtual Circuit (SVC) call to the
node and specifying subaddress 98.
Step Action
1 Set your terminal, or terminal emulation software, to VT100, 9600 bps,
8 bit, no parity, 1 stop bit.
2
Type
<CR>
until either an asterisk (*) or the OK prompt appears.
3 When you see OK, type
atds0 <CR>
. When you see the asterisk (*) type
.ctp
.
The CTP banner will appear. If this banner does not appear, verify that
these steps have been followed correctly.
4 Type
<CR>
at the password prompt, if no password has been set.