Morgensen MSI350 Series, Руководство пользователя, Страница: 215 / 388

215
2: In pulse detection mode
P13.02 Input current 1
Input current is the pole position orientation current;
input current 1 is valid within the lower limit of input
current switch-over frequency threshold. If users need
to increase the starting torque, increase the value of this
function code properly.
Setting range: 0.0%–100.0% (rated motor current)
20.0% ○
P13.03 Input current 2
Input current is the pole position orientation current;
input current 2 is valid within the upper limit of input
current switch-over frequency threshold, and users do
not need to change input current 2 under common
situations.
Setting range: 0.0%–100.0% (rated motor current)
10.0% ○
P13.04
Switch-over
frequency of input
current
0.00Hz–P00.03 (Max. output frequency) 10.00Hz
○
P13.05
High-frequency
superposition
frequency
(reserved)
200Hz–1000Hz 500Hz
◎
P13.06
Pulse current
setting
This parameter is used to set the pulse current
threshold when the initial magnetic pole position is
detected in the pulse mode. The value is a percentage
in relative to the rated current of the motor.
Setting range: 0.0–300.0% (of the rated voltage of the
motor)
100.0% ◎
P13.07
Reserved
variables
0.0–400.0 0.0 ○
P13.08
Control parameter
1
0–0xFFFF 0
○
P13.09
Control parameter
2
This parameter is used to set the frequency threshold
for enabling the counter-electromotive force phase-
locked loop in SVC 0. When the running frequency is
lower than the value of this parameter, the phase-locked
loop is disabled; and when the running frequency is
higher than that, the phase-locked loop is enabled.
Setting range: 0–655.35
2.00
○
P13.10
Reserved
variables
0.0–359.9 0.0
○