Morgensen MSI350 Series, Руководство пользователя, Страница: 206 / 388

206
BIT7 BIT6 3 00 01 10 11
BIT9 BIT8 4 00 01 10 11
BIT11 BIT10 5 00 01 10 11
BIT13 BIT12 6 00 01 10 11
BIT15 BIT14 7 00 01 10 11
P10.35
BIT1 BIT0 8 00 01 10 11
BIT3 BIT2 9 00 01 10 11
BIT5 BIT4 10 00 01 10 11
BIT7 BIT6 11 00 01 10 11
BIT9 BIT8 12 00 01 10 11
BIT11 BIT10 13 00 01 10 11
BIT13 BIT12 14 00 01 10 11
BIT15 BIT14 15 00 01 10 11
Select corresponding acceleration/deceleration time,
and then convert 16-bit binary number into
hexadecimal number, finally, set corresponding
function code.
Acceleration/deceleration time 1 is set by P00.11 and
P00.12; Acceleration/deceleration time 2 is set by
P08.00 and P08.01; Acceleration/deceleration time 3 is
set by P08.02 and P08.03; Acceleration /deceleration
time 4 is set by P08.04 and P08.05.
Setting range: 0x0000–0xFFFF
P10.36 PLC restart mode
0: Restart from the first step, namely if the inverter stops
during running (caused by stop command, fault or
power down), it will run from the first step after restart.
1: Continue running from the step frequency when
interruption occurred, namely if the inverter stops during
running (caused by stop command or fault), it will record
the running time of current step, and enters this step
automatically after restart, then continue running at the
frequency defined by this step in the remaining time.
0
◎
P10.37
Multi-step time
unit
0: s; the running time of each step is counted in
seconds;
1: min; the running time of each step is counted in
minutes;
0 ◎
P11 group Protection parameters
P11.00
Phase-loss
protection
0x000–0x111
Ones:
0x110 ○