Mopec Maestro MB1000 Series, Инструкция по установке, обслуживанию и эксплуатации

Страница: 43 / 60

Installation Service User Manual Maestro series MB1000-MAN rev.1 43
8 TROUBLESHOOTING AND REPAIR
8.1 How to Identify and Solve Problems
WARNING: Trouble shooting section is for reference only. Any repairs should be made by skilled and trained persons
following proper facility safety protocols
Error / issue / Failure Cause Solution
Power up Failure
My Station does not turn “ON”
G.F.C.I. has been tripped
Reset G.F.C.I. There are two per station. One
above shelf, and one in “Cord Wrap” area on side
of machine.
NOTE: Station must have main
power “ON” to reset GFCI.
Facility breaker has been
tripped
Reset facility breaker
Power system short
Check connections at the wire whip or power
cord and plug connector
Disconnect power check circuits & harness
connections
(REF 9.2)
Elevation Failures
My Station does not elevate
Station not turned “ON” Turn station “ON” at main power switch
G.F.C.I. has been tripped Reset G.F.C.I. (station power must be “ON”)
Elevation system needs to be
reset
Reset elevation system (
REF 7.1.4
)
Damage to Elevation system Replace linear actuator control box & button
Station tilting towards side,
front or back
Station not leveled correctly
Check leveling feet
Check for obstructions limiting travel in and
around the station
Station elevation system
sagging or drifting
Check for excessive weight on the unit in the
direction of the tilt
Reset elevation system (
REF 7.1.4
)
Replace linear actuator nearest tilt (operate in
lowest position pending service)