Mopec Maestro MB1000 Series, Инструкция по установке, обслуживанию и эксплуатации

Страница: 16 / 60

Installation Service User Manual Maestro series MB1000-MAN rev.1 16
 Strap the unit down across the worksurface and pull down towards the skid. Be sure to put padding on the
edges of the worksurface where the straps contact the sheet metal.
3.4 Disposal and Recycling
Disposal of the unit is ultimately up to local codes and guidelines. The following section breaks down the materials of
construction for recycling purposes.
3.4.1 Stainless Steel

The Hood is made entirely of 304 stainless steel. Remove all electronics and recycle appropriately.

The worksurface is also 304 stainless steel.
o Remove the faucets and fixtures as these are typically chrome plated brass in construction.
 The lower skirting is 304 stainless steel along with the frame cross connectors.
3.4.2 Ferrous Steel
 The only ferrous steel used on the Maestro is in the lower frame weldment where the linear actuators mount.
 If equipped with a magnetic tool bar this will also be made from steel.
3.4.3 Aluminum
 The elevation guide posts are made from aluminum located in the frame ends.
 If the unit is equipped with monitor and keyboard arm accessories those are also made of aluminum.
3.4.4 Plastic

The cutting board and formalin dispense tank lid are made of thick HDPE.

The waterlines, fittings, flexible vent ducts and collection carboys are typically made of thermoplastics like
polypropylene, vinyl and polyvinylchloride and should be recycled accordingly.
3.4.5 Electronics

The unit has internal circuitry, circuit boards, touch screen, LED lighting and actuators that should be
recycled as electronic components.