Mopec Maestro MB1000 Series, Инструкция по установке, обслуживанию и эксплуатации

Страница: 40 / 60

Installation Service User Manual Maestro series MB1000-MAN rev.1 40
the GFCI will only reset if power is supplied to the station. Check that your Main Power switch is on and
that your facilities circuit breaker is not tripped.
 Press the TEST and RESET buttons on the GFCI and confirm operation or status lights per diagram above.
 If the GFCI has reset and shows a green light the unit is ready to operate.
 If the GFCI fails there may still be a ground fault in the system or the GFCI unit may need to replaced. See the
section on Troubleshooting (8.0) or call Mopec Service (7.3)
7.1.6 Resetting the Auxiliary GFCI
The Maestro is equipped with an auxiliary GFCI power outlet for uninterrupted supply on a computer system or other
auxiliary devices plugged into the side panel. For this the unit only needs power supplied to the unit from the facility
and operates independently from the Main power switch. The reset procedure is the same as section 7.1.3 above.
7.2 Stainless Steel Maintenance & Cleaning
7.2.1 Disinfecting Stainless steel
All stainless steel surfaces can be cleaned with soap and water to remove tissue and debris. The stainless steel surfaces
can be disinfected with a non caustic disinfectant.

Always wipe in the direction of the stainless steel grain.
o We suggest using BE045 Path Cloud or BE047 Bench Wipe for cleaning purposes.
 Most disinfectants must be followed up with a water rinse to remove the salts that remain after these products
dry. Always follow up a disinfection cleaning with a thorough rinse of water.
 DO NOT USE a straight bleach solution to clean your unit. Bleach will eventually erode stainless steel if not
thoroughly rinsed.
o Erosion from chlorine bleach is detectable and will void the warranty.
o
If your process must use chlorine bleach it must not exceed 10% and must be rinsed immediately after
disinfection to avoid damage to the metal.