Mopec Maestro MB1000 Series, Инструкция по установке, обслуживанию и эксплуатации

Страница: 11 / 60

Installation Service User Manual Maestro series MB1000-MAN rev.1 11
3 Installation
Notice: If you have purchased installation from Mopec your installer will cover section 3
3.1 How to unpackage your workstation
3.1.1 Check for freight damage

If the unit has sustained damage during transit or during unloading from carrier now is the time to file a
freight claim.
Many large institutions use their own carriers. A freight claim would file with that provider.

Check for damage to the skid that would result in an unsupported or twisted station.

Check that the sides of the crate have not been punctured or smashed.

Check that the top of the crate has not sustained damage or has evidence of being placed upside down.

Take photographs of any damage and contact Mopec or your private freight carrier if applicable.
3.1.2 Uncrating Contents

Remove the top boards from the crate. Place in dumpster or out of the way to dispose of later. Watch for
staples, nails and slivers of wood.

Remove the side boards, end boards and plywood from the crate.

Remove the corner posts of the crate. Pull downward and then sideways to break away from the base.

Remove all the bracing at the bottom of the skid. Note the small 2”x 4” blocks nailed to prevent the unit
from moving.

Carefully cut the plastic wrap so the unit is not scratched and components are not damaged.

Unwrap the plastic wrap and foam from the unit.

Cut and remove and the metal banding material securing the unit.

Look the unit over for hidden damage. If found, take photos and contact Mopec.
 Remove any optional equipment from the sink, under the sink or behind the doors (if so equipped).

Ensure all plumbing and wiring is secured and up and out of the way before moving the unit.
3.1.3 Removing Unit from Skid;

Ensure there is plenty of room to work around the unit.

Tip the unit forward to retract the back leveling feet to allow the unit to slide on the crate floor.

Tip the unit back to retract the front leveling feet to allow the unit to slide on the crate floor.

Slide the unit back a little more than halfway off the skid, and tilt back until the bottom edge is resting on
the floor. Tip the unit back a little farther so the skid can be pulled out from under the unit.

Then gently put the unit upright on its base, making sure not to drop the unit.