Mopec Maestro MB1000 Series, Инструкция по установке, обслуживанию и эксплуатации

Страница: 13 / 60

Installation Service User Manual Maestro series MB1000-MAN rev.1 13
Do not use a powered screw gun to remove or install the screws. A screw gun can damage the PEM
nut in the sheet metal.

Once the skirting has been removed the electrical can be connected by the appropriate personnel.

If equipped with a cord with a plug, plug in to the provided wall outlets.

If hard wiring the station, cut the zip ties that secure the factory supplied electrical whip and prep the wire
ends for final connection to the facility.

The electrical system should then be tested per local codes or guidelines at this time.
o The workstation utilizes a multiwire branch circuit.

(1) 115/1/60, 20amp circuit labeled L1 powers the controls and power outlets.

(1) 115/1/60, 20amp circuit labeled L2 powers the disposal.
3.1.7 Plumbing Connection;
 Check that the internal flexible drain line is present and still connected to the P-Trap assembly free from any
obstruction. The unit is shipped fully lowered in elevation so the flex line will appear flattened out.
Lowered Raised

With the plumbing bracket mounted to the factory location on the frame (as shown in image above) the
facility drain line can be connected either via a flexible line with hose clamps or hard plumbed per your local
codes and regulations. The unit is designed to drain properly in this configuration if roughed in per the
drawing.