Moog MSD C2, Руководство по эксплуатации

Страница: 24 / 72

24
MSD Single-Axis Servo Drive Compact Operation Manual
ID no.: CA97555-001 Date: 04 /201 8
moog
Detail 3: Mains filter and mains connection
At the output of the mains filter and the AC mains connection X3):
y
Connect the litz wire on the output of the mains filter directly to the AC mains connection (X3) on
the MSD Single-Axis Servo Drive Compact. The litz wires must
not
be extended, so the mains
filter should be installed correspondingly close to the MSD Single-Axis Se r vo Drive Compact. But
be sure to maintain the necessary minimum clearance (see “Table 3.3 MSD Single-Axis Servo
Drive Compact mounting clearances”).
y Fix the litz wire to the shield connection plate using a cable tie as necessary.
y
The leakage current of the MSD Single-Axis Ser vo Drive Compact is >3.5 mA. So:
− Connect the protective earth conductor from the output of the mains filter to conne tion (X3)
on the MSD Single-Axis Servo Drive Compact C2 to B4 or to the housing of the
MSD Single-Axis Servo Drive Compact C5
and
− One of the PE connections on the heat sink on the MSD Single-Axis Servo Drive Compact
using a cable of at least the same cross-section to the main earth for the distributor rail.
Figure 4.11 Specimen setup - Detail 3: Mains filter and mains connection
X3
Detail 2: Contr ol supply (+24 V DC)
At the connection for the control voltage (X2) pay attention to:
y
Secure the second of the two shield connection plates supplied to the mount on the bottom of
the unit using the screw. Ensure the plate is in contact over a large area with the heat sink on the
MSD Single-Axis Servo Drive Compact and with the backing plate. Use a serrated washer.
y
Pull a shielding sleeve over the control supply cable and strip it back only as short as necessary
before the control supply connection (X2).
y
Connect the shielding sleeve on the control supply cable with a large area connection to the
shield connection plate using the clamp supplied.
Figure 4.10 Specimen setup - Detail 2: Control supply
X2